Ingredients to a Moe-full Tail and Ears.
1 ) Cut the Wire into the Desired Length.
2 ) Cut the Yarn into a length where you think you can wind around the tail to make it fatter.
3 ) Locate 1 side of the yarn, tie a Knot on the wire with the yarn.
4 ) Cut off the excess yarn behind of the knot… There will be 2 ends, one with a ton of yarn, and one with just a little cut the one with a little.
5 ) Use the ton of yarn and spin it on the wire to form a fat tail.
6 ) After spinning to a point where there will not be any yarn left, leave some excess and tie another knot using the yarn around of the wire.
7 ) Tear a fluff of cotton wool and place it at the tip of the tail.
8 ) Use the needle and thread to impale the cotton wool into the tail.
Some Emphasis on the cotton wool.
9 ) Glue the side without of the cotton wool to prevent it from warping and unraveling into yarn again.
10 ) Wait for it to dry.
Left: Prototype, Right: Model 01
Haruhi with Prototype Nekomimi and Model 01 Shipo
Thanks Kodomut for tips on photography!!